Jetter JetWeb JetMove 203-230 User Manual page 66

9 Diagnostics
Error Type of Error
Number
F 05 Current overload
F 06 Overload internal
ballast resistor
F 07 Shutdown
threshold for
device temperature
F 08 Shutdown
threshold for motor
temperature
F 09 Encoder error
F 10 Overspeed
F 11 Current overrange
66
Error Message Table JetMove 203-230
Description
The output current
has been greater
than 2.5 x the rated
current
The ballast resistor
has been
overloaded
The amplifier has
reached the
maximum
temperature
The motor has
reached the
maximum
temperature
Encoder breakage
or initialization error
The actual shaft
speed has
exceeded a value of
1.25 x maximum
speed
A current
temporarily too high
has been detected
Effect Error Correction
– Immediate – Check cable and
pulse disable motor for a short
circuit
– Check current control
parameters. If
necessary, correct
parameters
– Acknowledge failure
– Immediate – Let the drive
pulse disable controller cool down
– After cooling down,
acknowledge failure
– Reduce regeneration
power
– Immediate – Let the drive
pulse disable controller cool down
– After cooling down,
acknowledge failure
– Reduce power of
drive system
– Immediate – Let the motor cool
pulse disable down
– After cooling down,
acknowledge failure
– Reduce the power of
the drive
– Immediate – For extended
pulse disable diagnostics purposes
use motion setup
– Check the encoder
line and all plug-in
connections
– Acknowledge failure
– Immediate – Check motor and
pulse disable encoder connections
– Check speed
controller parameters
If necessary, modify
parameters
– Acknowledge failure
– Immediate – Reduce K
pulse disable current controller by
10 to 20 %
– Acknowledge failure
JetWeb
of the
p
Jetter AG