Diagnostics; Fault Messages - Jetter JM-206-230 User Manual

JetMove 206B-230
9
9.1
Error Type of Error
Number
F 00 Hardware error
F 01 Internal voltage
supply error
F 02 Mains phase error
(is only active in
case of a 3-phase
connection)
F 03 Motor cable
breakage
F 04 Overvoltage in the
DC link
Jetter AG

Diagnostics

Fault Messages

Note!
In the case of a fault message, the letter "F" and two successive numbers appear
on the seven-segment display every second.
Fault Message Table JetMove 206B-230
Description
Internal hardware
defect
One or more power
supply voltages are
beyond their limits.
Failure of one of the
mains phases.
The motor cable is
broken.
Please be careful:
The motor cable is
tested when the
drive controller is
enabled for the first
time.
A DC link voltage of
> 480 V is detected.
Reaction Remedy
– Immediate – Separate the drive
motor power controller from the
disable power lines.
– Return the amplifier for
repair.
– Immediate – Separate the drive
motor power controller from the
disable power lines.
– Return the amplifier for
repair.
– Immediate – Check fuses and wiring.
motor power – Acknowledge failure.
disable
– Immediate – Check the motor cable
motor power connections.
disable – Acknowledge failure.
– Immediate – Check input voltage
motor power supply.
disable – If the motor is used as
generator, reduce the
regenerating power.
– Acknowledge failure.
9.1 Fault Messages
73