Warnings - Jetter JetWeb JetMove 203-230 User Manual

JetMove 203-230
Error Type of Error
Number
F30 I²t Error
F31 Motor overload
protection
according to UL
9.2
If the dot in the 7-segment display is flashing, one or several warnings have been
recognized. Please check in the motion setup or by making enquiries in the PLC
program which warning is active by means of the motion commands.
Jetter AG
Error Message Table JetMove 203-230
Description
The average power
loss of the motor
was more than the
max. value
configured by
nominal motor
current, overload
factor and motor
time constant
See "I²t calculation"
on page 39
The average motor
power loss was
higher than has
been defined
according to UL See
chapter 5.2.3 "Motor
overload calculation
according to UL",
page 41

WARNINGS

Effect Error Correction
– Immediate – Let the motor cool
pulse disable down
– Acknowledge failure
– Check the
configuration of
nominal motor
current, overload
factor and motor time
constant
– Reduce the average
load of the motor
– Immediate – Let the motor cool
pulse disable down
– Acknowledge failure
– Reduce the average
load of the motor
9.2 WARNINGS
69