Table of Contents
Advertisement
2 Installing the JetMove 203-230
2.2
22
Mechanical Installation
Prior to installing the digital servo amplifier, check it for possible
transport damages.
Check the shipment for completeness.
To ensure proper functioning of the JetMove 203-230 check whether
the mounting plate in the electric cabinet is unpainted.
The only possible mounting direction is vertical - see Fig. 4, page 23.
Please make sure there is a clearance of at least 100 mm under and
above the JetMove 203-230 - unobstructed ventilation must be granted.
Please mark on the panel two positions for the fastening screw threads
of the JetMove 203-230 (see Fig. 4, page 23).
Drill the holes and cut the thread into the panel.
Screw the corresponding fitting bolts into the thread by approximately
half of their length.
By means of the oblong holes in the rear plate, hang up the JetMove
203-230 by the fitting bolts; then screw them tightly.
JetWeb
Jetter AG
Advertisement
Table of Contents
