Table of Contents
Advertisement
10 10
Assembly
10-1 Assembly diagram
The numbers in the following diagram represent the order to attach each unit.
The units shown in the diagram are typical units. For units which are not described below, contact Olympus or refer to
the latest catalogs.
Before assembling the microscope, remove dust and dirt from the mount of each unit and assemble
NOTE
them carefully to prevent from scratches.
The procedures to assemble the units shown by
· Assemble the units using the Allen screwdriver (opposite side: 3 mm
TIP
(opposite side: 4 mm or 3 mm
wrench (Opposite side: 3 mm) for purposes other than attaching the revolving nosepiece.
· For the scale slider GX-SLM, refer to the instruction manuals provided separately.
Eyepiece
7
Control boxes
Power cord
Filter
Filter slider
Polarizer
Connection plate
Stage center plate
5
Observation tube
Observation tube
clamping screw
6
17
Analyzer
Scale slider
GX-SLM
numbers are described on the next page and after.
) provided with the microscope frame. Do not use the Allen
Stage
Lamp housing
clamping screws
(2 positions)
LED light source
1
3
Microscope frame
GX53F
18
Microscope frame
GX53F
C mount camera
) and the Allen wrench
Light sources other than LED
(See page 78.)
Brightfield/
Brightfield
darkfield
objective
objective
Adapter
2
Coded
Revolving
revolving
nosepiece
nosepiece
4
DIC slider
MIX slider for reflected light observation
Digital camera
adapter
GX53
65
Advertisement
Table of Contents
