Attaching The Observation Tube; Attaching The Eyepiece - Olympus GX53 Instructions Manual

Inverted system metallurgical microscope

Table of Contents

This picture shows the procedure to attach the

binocular tube (U-BI90). The same procedure

applies when attaching other observation tubes.

Attaching the observation tube

If the eyepieces are attached to the observation tube, remove the eyepieces

before attaching the observation tube.

NOTE

For attaching procedures, see "6-1 Replacing the eyepiece" on page 45 .

Loosen the clamping screw a of the microscope frame until the

clamping screw is hidden looking from above (until there is no feeling

of protrusion when touched by fingers).

Insert the circular dovetail b of the observation tube under the

protrusions c (2 positions) on the mount of the microscope frame.

Adjust the direction of the observation tube so that the value of the

interpupillary distance adjustment scale on the observation tube faces

to the front, and tighten the clamping screw d of the standard arm

to secure it.

If the observation tube moves when you attempt to rotate

it, the observation tube is not fixed properly. Tighten the

clamping screw again.

GX53

Table of Contents