Table of Contents
Advertisement
a
b
c
a
Layout of the cable for MIX slider for reflected light observation
1
Attach the cable holder a on the left side of the microscope.
The cable holders (3 pcs.) are provided with the cable for MIX
TIP
slider (U-MIXRCBL).
2
Open the cable holder a , put the cable for MIX slider for reflected
light observation (U-MIXR) between the cable holder, and close the
cable holder.
If you disconnect the connector from the MIX slider for
TIP
reflected light observation, store the cable between the cable
holder as shown as b .
When the connector is disconnected, the indicator c of the
MIX slider for reflected light observation turns OFF.
Indicator of MIX slider for reflected light observation
When the connector is connected
When the connector is not connected
Layout of the cable for coded nosepiece
1
Attach the cable holder a on the left side of the microscope.
If you use the coded function system (U-CBS), the cable
TIP
holder is provided with U-CBS.
2
Open the cable holder a , put the cable for coded nosepiece between
the cable holder and close the cable holder.
GX53
Turns ON
Turns OFF
75
Advertisement
Table of Contents
