Table of Contents
Advertisement
CAUTION - Carrying the product -
a
b
c
Handling Precautions
· This product is a precision instrument. Handle it with care and avoid subjecting it to a sudden or severe
NOTE
impact.
· Never disassemble any part of the product. Otherwise, failure may result.
· Do not use the product in areas where it may be subjected to direct sunlight, high temperature and/or
humidity, dust or vibrations.
(For conditions of operating environments, see "8 Specifications" on page 60).
· Before attaching or detaching the units other than the MIX slider for reflected light observation
(U-MIXR), set the main switch of the microscope to
· If units are not attached, be sure to attach the caps that are attached to the unit mounts to prevent
from dust.
· When observing a heavy sample exceeding 1 kg or using this product on a desk subject to external
vibration, if the vibration bothers you, use the anti-vibration table.
· Remove the pad for protecting the focusing unit that is attached as factory default. For removing
procedures, see "Attaching the stage" on page 72.
Remove samples and units attached.
1. Make sure that the stage and revolving nosepiece are attached
securely. If the illumination column is attached, make sure that the
illumination column in tilted status is secured.
2. Be sure to remove samples and units, such as observation tube,
camera adapter and lamp housing, etc.
If you carry the microscope with units attached, the weight is
increased and the risk of dropping the microscope may be caused.
Be sure to carry the microscope by two persons.
When carrying the microscope, be sure to carry it by two persons. One
person holds the front holding section a and the other person holds
the rear holding section b as shown in the picture on the upper left.
If the illumination column for transmitted light observation is attached,
hold the holding section c as shown in the picture on the lower left.
Do not slide on the top surface of the table.
Do not move the microscope by sliding it on the top surface of the
table. The rubber legs may be damaged.
If you need to pack this product for shipping to
a distant location, etc., the dedicated transport
tools and packaging materials are necessary.
Be sure to contact Olympus for assistance.
(OFF)
.
GX53
7
Advertisement
Table of Contents
