Olympus GX53 Instructions Manual page 61

a
b
2
e
c
Attaching to GX-FSL
1
Place the filter slider on the desk with the display surface a of the
slider facing up.
d
2
Insert the dedicated screwdriver d provided with the microscope
frame into the notch c on the filter holding ring b and rotate the
screwdriver counterclockwise to remove the filter holding ring b .
3
Insert the filters with display surfaces e of the slider facing up.
4
Screw in the holding ring b to clamp firmly.
When using two filter sliders
3
Insert the filters with display surfaces e of the slider facing down.
TIP
4
Screw in the holding ring b to clamp firmly.
The filter display surface e is same direction when the filter
sliders are set to the microscope frame, bacause the filter slider
is used upside down.
GX53
55