Refitting The Gear Interlock Plunger And Pawl Assembly - Ducati Monster 696 2009 Manual

section
N 7.1

Refitting the gear interlock plunger and pawl assembly

A
Fit the pawl (4), washer (2) and spring (1) on the retaining screw (3).
Fit the assembled unit on the clutch-side crankcase half, locating the end of the spring (1) behind the crankcase rib.
Tighten the screw (3) to the specified torque (Sect. C 3, Engine torque settings).
On the special screw (3), fit the gear pawl lever (4), orienting it as shown in the figure, the washer (2) with the square edge
side (D) facing the clutch-side crankcase, and the spring (1), positioning it so that the hook end (A) is facing the gear pawl lever.
Locate the hook end (A) of the spring on the gear pawl lever as shown in the figure.
B
Start the screw in the crankcase half. Position end (B) of the spring so that it rests against rib (C) of the crankcase half, as
shown in the figure. Tighten the screw (3) to the specified torque (Sect. C 3, Engine torque settings). Check that the spring
functions correctly by manually moving the gear pawl lever.
C
D
E
F
G
H
L
M
N
P
116
Engine
A
1
2
3
4
2
1
D
B
A
A
B
C
3
4
Monster 696/696+ - M.Y. 2009 - edition 00