Ducati Monster 696 2009 Manual page 453

section
N 4.4
Once the specified clearance has been obtained, remove the camshaft (C), lubricate it with graphite oil and reinstall it in the
cylinder head.
Insert the rocker arm shaft (4) with the threaded hole on the external side of the cylinder head: the seal (5) should be renewed
on installation; lubricate it before fitting.
Locate the opening rocker arm (3) and the two shims (2) on the shaft (4).
Refit the camshaft end cap (Sect. N 4.3, Refitting the camshaft end caps).
Refit the camshaft timing pulleys (Sect. N 4.2, Refitting the timing belt driveshaft pulleys).
Locate the valve opening shim (6) on the valve stem.
With the valve in rest position, check that clearance between the rocker arm (3) and the shim (6) is within the specified tolerance
limits (Sect N 4.1, Checking the opening clearance (Sa) of the intake/exhaust valves).
If not, adjust the valve clearance (Sect. N 4.1, Checking and adjusting valve clearances.
Monster 696/696+ - M.Y. 2009 - edition 00
Engine
C
4
5
4 3
3
6
B
2
4
A
B
C
D
E
F
G
H
L
M
N
P
71