Ducati Monster 696 2009 Manual page 99

section
D 5
Take the measurement on section (23) of the horizontal belt as described in the paragraph "Measuring timing belt tension".
Turn the crankshaft through 270° in the direction of rotation of the engine (so that the piston of the vertical cylinder is at TDC of
the power stroke) and repeat the procedure used for the horizontal cylinder, measuring the tension on section (22) of the vertical
cylinder timing belt.
Remove the belt tension sensor and disconnect the DDS tester from the motorcycle.
Operation
Refit the timing belt covers
Measuring timing belt tension
Switch on the DDS tester (1); see paragraph "Tester power supply".
Connect the power and diagnostics cable (Measurement Module) (3) to the measurement module connector (F) on the DDS
tester (1).
Connect the belt tension sensor (15) to the connector (V) of the power and diagnostics cable (Measurement Module) (3).
Monster 696/696+ - M.Y. 2009 - edition 00
Use and maintenance
Vertical
Idler
Tensioner
Idler
22
Timing belt
23
Tensioner
Section reference
N 4.2, Refitting the timing belt covers
1 3
V
3
Horizontal
F
15
A
B
C
D
E
F
G
H
L
M
N
P
47