Adjusting The Position Of The Gearchange And Rear Brake Pedals - Ducati Monster 696 2009 Manual

section
D 4

Adjusting the position of the gearchange and rear brake pedals

The position of the gearchange and rear brake pedals in relation to the footrests can be adjusted to suit the preferred riding
position.
To adjust the position of the gearchange pedal, proceed as follows.
Restrain the tie-rod (1) and slacken the locknuts (2) and (3).
Notes
The locknut (2) has a left-hand thread.
Turn the tie-rod (1) using an open-ended wrench on the flats to move the gearchange pedal to the required position.
Tighten both lock nuts onto the rod.
To adjust the position of the rear brake pedal, proceed as follows.
Loosen the locknut (4).
Turn the pedal travel adjustment screw (5) until the pedal is in the desired position.
Tighten the locknut (4).
Operate the pedal by hand to make sure it has 1.5 to 2 mm of free play before the brake begins to bite.
If not, adjust the length of the master cylinder pushrod as follows.
Slacken off the locknut (7) on the pushrod.
Screw the rod into the clevis (6) to increase play, or unscrew it to reduce play.
Tighten the locknut (7) and recheck the pedal freeplay.
Monster 696/696+ - M.Y. 2009 - edition 00
Use and maintenance
1
2
4
5
3
7
6
A
B
C
D
E
F
G
H
L
M
N
P
37