Advertisement
3-10
Purpose
Adjustment
Function (Purpose) Used to adjust the finisher.
Section
Finisher
Operation/Procedure
1)
Select an adjustment target item with scroll key on the touch
panel.
2)
Enter the set value with 10-key.
3)
Press [OK] key. (The set value is saved.)
Inner finisher (MX-FN23)
Item/Display
A
FPAM ADJUST
Paper alignment width
adjustment
B
FDRLM ADJUST
Paper exit roller descending
position adjustment
4
4-2
Purpose
Operation test/check
Function (Purpose) Used to check the operations of the sen-
sors and detectors in the desk, and the
control circuit of those.
Section
Desk
Operation/Procedure
The operating conditions of the sensors and detectors are dis-
played.
The code names of the sensors and the detectors which are active
are highlighted.
Desk
Display
C3PFD
Cassette 3 paper entry sensor
C3LUD
Cassette 3 paper upper limit sensor
C3PED
Cassette 3 paper empty sensor
C3SS
Cassette 3 installation sensor
DSW_C3
Cassette 3 door open/close sensor
C4PFD
Cassette 4 paper entry sensor
C4LUD
Cassette 4 paper upper limit sensor
C4PED
Cassette 4 paper empty sensor
C4SS
Cassette 4 installation sensor
DSW_C4
Cassette 4 door open/close sensor
Setting
Content
range
40 - 60
40 - 60
Content
MX-M316N SIMULATION 6 – 10
Default
Change when the adjustment value is
value
increased or decreased
50
When the adjustment value is increased, the
width of the alignment plate F/R during
alignment operation is decreased.
When the adjustment value is decreased, the
width of the alignment plate F/R during
alignment operation is increased.
50
When the adjustment value is increased, the
descending position of the paper exit roller is
shifted to the compression side.
When the adjustment value is decreased, the
descending position of the paper exit roller is
shifted to the decompression side.
4-3
Purpose
Function (Purpose) Used to check the operations of the loads
Section
Operation/Procedure
1)
Select the load item that is required to operation check with the
touch panel key.
2)
Press [EXECUTE] key.
The selected load performs the operation.
When [EXECUTE] key is pressed, the operation is terminated.
Desk
Display
CPFM
Desk motor
PTRC1
Desk vertical transport clutch
C3LUM
Cassette 3 lift-up motor
C3PUC
Cassette 3 paper feed clutch
C4LUM
Cassette 3 lift-up motor
C4PUC
Cassette 4 paper feed clutch
Change when the adjustment
value is changed by 1
0.419mm
0.13mm
Operation test/check
in the desk, and the control circuit of those.
Desk
Content
Advertisement
