Advertisement
ADJ 16
Finisher adjustments
(alignment, staple position)
This adjustment must be performed in the following cases:
* When the finisher is disassembled.
* When the finisher control PWB is replaced.
* When the alignment is improper.
* When the staple position is shifted.
1)
Enter the SIM 3-10 mode.
2)
Select an adjustment target item with the scroll key.
Inner finisher
Item/Display
A
FPAM ADJUST
Alignment width adjustment
B
FDRLM ADJUST
Paper exit roller descending
position adjustment
3)
Enter an adjustment value and press [OK] key.
4)
Cancel the simulation, make a copy in the mode including the
adjustment target, and check the adjustment result.
Setting
Default
Content
range
value
40 - 60
50
40 - 60
50
MX-M316N ADJUSTMENTS AND SETTINGS 5 – 39
Advertisement
