Advertisement
26-18
Purpose
Setting
Function (Purpose) Used to set Disable/Enable of the toner
save mode operation.
(For the Japan and the UK versions.)
Section
Operation/Procedure
1)
Select an item to be set with scroll keys.
2)
Enter the set value with 10-key.
3)
Press [OK] key.
The set value in step 2) is saved.
Item
Display
A
COPY
0
Copy toner save mode is inhibited.
1
Copy toner save mode is allowed
B
PRINTER
0
Printer toner save mode is inhibited.
1
Printer toner save mode is allowed.
26-30
Purpose
Setting
Function (Purpose) Used to set the operation mode corre-
sponding to the CE mark (Europe safety
standards). (For slow start to drive the fus-
ing heater lamp)
Section
Operation/Procedure
1)
Enter the set value with 10-key.
0
Control allowed
1
Control inhibited
2)
Press [OK] key.
The set value in step 1) is saved.
* Even in Enable state, the control may not be executed due
to the power frequency, etc.
U.S.A
1 (CE not supported)
CANADA
1 (CE not supported)
INCH
1 (CE not supported)
JAPAN
1 (CE not supported)
AB_B
1 (CE not supported)
26-32
Purpose
Setting
Function (Purpose) Used to set the special functions.
Section
Operation/Procedure
1)
Enter the set value with 10-key.
2)
Press [OK] key.
The set value in step 1) is saved.
Item/Display
Content
A
CLEANING
The screen of the
PRINT SET
cleaning mode self print
execution is displayed.
(ON)
The screen of the
cleaning mode self print
execution is not
displayed. (OFF)
Default
Content
value
0
0
EUROPE
0 (CE supported)
U.K.
0 (CE supported)
AUS.
0 (CE supported)
AB_A
0 (CE supported)
CHINA
0 (CE supported)
Default
Setting range
value
0
YES
1(NO)
1
NO
MX-M316N SIMULATION 6 – 28
26-35
Purpose
Setting
Function (Purpose) Used to set the display mode of SIM 22-4
trouble history when a same trouble
occurred repeatedly. There are two display
modes: display as one trouble and display
as several series of troubles.
Section
Operation/Procedure
1)
Enter the set value with 10-key.
0
Only once display.
1
Any time display.
2)
Press [OK] key.
The set value in step 1) is saved.
26-38
Purpose
Setting
Function (Purpose) Used to set Continue/Stop of print when the
maintenance life is reached.
Section
Operation/Procedure
1)
Enter the set value with 10-key.
2)
Press [OK] key.
The set value in step 1) is saved.
Item/Display
A
MAINTENANCE
0
LIFE OVER
(0: CONTINUE
1: STOP)
1
26-49
Purpose
Setting
Function (Purpose) Used to set the print speed of postcards
mode.
Section
Operation/Procedure
Select the copy speed mode with the touch panel. (Default: LOW)
Item
Setting
value
POSTCARD
LOW
Postcard copy speed LOW
HIGH
Postcard copy speed HIGH
Content
Setting of Print Continue/
Stop when the maintenance
life is over (Print Continue)
Setting of Print Continue/
Stop when the maintenance
life is over (Print Stop)
Content
LOW
Default
value
0
Default
value
Advertisement
