Advertisement
2-3
Purpose
Operation test/check
Function (Purpose) Used to check the operations of the loads
in the automatic document feeder and the
control circuit.
Section
RSPF
Operation/Procedure
1)
Select a target item of the operation check with the touch panel
key.
2)
Press [EXECUTE] key.
The selected load performs the operation.
When [EXECUTE] key is pressed, the operation is terminated.
<56opm>
Display
SPUM_F
RSPF paper feed motor (normal rotation)
SPUM_R
RSPF paper feed motor (reverse rotation)
SPFM_F
RSPF transport motor (normal rotation)
SPFM_R
RSPF transport motor (reverse rotation)
SRRC
Registration roller clutch (RSPF)
SPRS
Pressure release solenoid (RSPF)
STMPS
Stamp solenoid
<31opm>
Display
SPUM_F
RSPF paper feed motor (normal rotation)
SPUM_R
RSPF paper feed motor (reverse rotation)
SPUC
Paper feed clutch (RSPF)
SRRC
Registration roller clutch (RSPF)
SPRS
Pressure release solenoid (RSPF)
STMPS
Stamp solenoid
3
3-2
Purpose
Operation test/check
Function (Purpose) Used to check the operations of the sen-
sors and the detectors in the finisher and
the control circuit.
Section
Finisher
Operation/Procedure
The operating conditions of the sensors and detectors are dis-
played.
The code names of the sensors and the detectors which are active
are highlighted.
Inner finisher (MX-FN26)
Display
FAPHPS_F
Paper alignment plate HP sensor F
FAPHPS_R
Paper alignment plate HP sensor R
FDRPS
Paper exit roller position sensor
FDTLLS
Paper exit tray lower limit sensor
FDTPD
Delivery tray paper detector
FPHPS
Punch unit home position sensor
FPLD
Paper height detector
FPLS
Paper surface sensor auxiliary detector
FPMRS
Punch motor rotation sensor
FPPD1
Paper entry detector
FPRD
Compiler paper rear edge detector C
FSED
Staple empty detector
FSHPS
Staple HP sensor
FSLD
Staple lead edge detector
FSSW
Safety switch
FSTPD
Staple tray paper detector
FTPS
Tray position sensor
Content
Content
Content
MX-M316N SIMULATION 6 – 9
3-3
Purpose
Operation test/check
Function (Purpose) Used to check the operation of the load in
the finisher and the control circuit.
Section
Finisher
Operation/Procedure
1)
Select the item to be operation checked with the touch panel
key.
2)
Press [EXECUTE] key.
The selected load performs the operation.
When [EXECUTE] key is pressed, the operation is terminated.
Inner finisher (MX-FN26)
Display
FCF
Cooling fan
FDRLM
Paper exit roller lift motor
FPAM_F
Paper alignment motor F
FPAM_R
Paper alignment motor R
FPDM
Paper exit motor
FPGS
Paper gate solenoid
FPS
Paddle solenoid
FARLS
Finisher alignment roller lift solenoid
FPTM
Paper transport motor
FSL
Illumination of the staple unit
FSM
Staple motor
FTLM
Tray lift motor
Content
Advertisement
