Advertisement
Item/Display
E
TONER END
Setting of the
COUNT
number of copy/print/
FAX outputs Enable
after TONER NEAR
END.
F
TONER E-MAIL
0
ALERT
1
Item E (TONER END COUNT) setting value and printable quan-
tity
Setting value
Printable quantity at A4/6% equivalent conversion
1
2
3
4
5
Contents of set items
A: Enable/Disable setting of the toner preparation message display.
B: The toner remaining quantity at which the toner preparation
message is displayed.
C: Enable/Disable setting of the toner preparation message display
when the toner near end status is reached.
D: Machine operation at toner end
E: Number of allowable copy/print/FAX when the toner near end
message is displayed. (Range: 0 - 160 sheets)
The number of output print allowed in item D is based on the
assumption that the sheets are of A4 size with print ratio of 6%.
(The number of outputs allowed differs depending on the paper
size and the print ratio.)
CAUTION: When item A is set to "0" and item E is properly set,
printing can be made after toner near end. However,
improper phenomena such as insufficient density, thin
spots, or improper color balance may result depending
on the using conditions. When item E is set to "1" print-
ing is disabled after toner near end. In this case, toner
end display is made in the toner near end status, and
copy/print/FAX outputs are disabled.
Setting
Default
Content
range
1 - 5
Low status send
0 - 1
of E-mail alert
(When the toner
preparation
message is
displayed) (in
near near toner
end)
Low status send
of E-mail alert
(near toner end)
0
20
40
80
160
MX-M316N SIMULATION 6 – 31
26-73
value
Purpose
4
Function (Purpose) Enlargement continuous shoot, A3 wide
Section
1
Operation/Procedure
1)
Select an item to be set with scroll keys.
2)
Enter the set value with 10-key.
3)
Press [OK] key.
When the adjustment value is increased, the image loss
(shade delete quantity) is increased.
Item/Display
A
DELETING
SHADOW ADJ
(M)
B
DELETING
SHADOW ADJ (S)
26-74
Purpose
Function (Purpose) Used to set the OSA trial mode.
Section
Operation/Procedure
1)
Enter the set value with 10-key.
2)
Press [OK] key.
Item/Display
A
OSA TRIAL MODE
(0: YES 1: NO)
26-78
Purpose
Function (Purpose) Used to set the password of the remote
Section
Operation/Procedure
1)
Enter a password with 10-key. (5 - 8 digits)
The entered password is displayed on the column of "NEW".
In order to correct the entered password, press the [clear] key
to delete the entered value one digit by one digit.
2)
Press [SET] key.
Setting
copy mode image loss (shade delete quan-
tity) adjustment
Setting
Content
range
Rear frame side
0 - 50
image loss quantity
(shade delete
quantity) adjustment
Lead edge image
0 - 50
loss quantity (shade
delete quantity)
adjustment
Setting
Setting
Content
range
0
Used to set the
0 - 1
OSA trial mode.
1
OSA trial mode is
canceled.
Setting
operation panel.
Default value
0
(Adjustment
amount:
0.1mm/step)
0
(Adjustment
amount:
0.1mm/step)
Default
value
1
Advertisement
