Table of Contents
Advertisement
Functional Test
N2797A User's Guide
Use the following generic measurement procedure to ensure
that your probe is functioning properly.
1
Connect the probe to an oscilloscope channel input and
ensure the input impedance of the oscilloscope matches the
output impedance of the probe (50W).
2
Connect a grounding accessory to the probe and connect the
ground to the ground terminal on the oscilloscope.
3
Connect the probe tip to the oscilloscope's probe
compensation output.
4
Enable autoscale on the oscilloscope.
5
A square wave should now be displayed on the oscilloscope,
if the probe is functioning properly.
Using the Probe
1
Functional Test
21
Advertisement
Table of Contents
