Headlights; Headlight Adjustment; Headlight Bulb Replacement - Polaris RANGER XP 900 2013 Manual

ELECTRICAL

HEADLIGHTS

HEADLIGHT ADJUSTMENT

1. Place the vehicle on a level surface with the
headlight approximately 25 ft. (7.6 m) from a wall.
2. Measure the distance from the floor to the center of
the headlight (X 1 ) and make a mark on the wall at the
same height (X 2 ).
3. With the vehicle in Park, start the engine and turn the
headlight switch to the LOW position.
4. The most intense part of the LOW headlight beam
should be aimed 8 in. (20 cm) below the mark placed
on the wall in Step 2.
Rider weight must be included in the seat while
performing this procedure.
5. Remove the hood and locate the adjustment screw
(A) on the side of the headlight housing (B). Adjust
the beam to the desired position by loosening the
adjustment screw and moving the lamp to the
appropriate height.
10.18
NOTE
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
6. Once the beam is set to the position, tighten the
adjustment screw. Repeat the procedure to adjust
the other headlight.
WARNING
Due to the nature of light utility vehicles and where they
are operated, headlight lenses become dirty. Frequent
washing is necessary to maintain lighting quality. Riding
with poor lighting can result in severe injury or death.

HEADLIGHT BULB REPLACEMENT

1. Remove the hood from the front cab.
2. Locate the bulb on the back side of the headlight
housing.
3. Disconnect the harness (C) from the bulb. Be sure to
pull on the connector, not on the wiring.
4. Turn the bulb counterclockwise and remove it from
the headlight housing.
© Copyright Polaris Sales Inc.