Polaris RANGER XP 900 2013 Manual page 273

CLUTCHING
3. Compress spider buttons for each tower and install
spider, making sure that "X" or the marks that were
made earlier on the spider, aligns with "X" or the
marks that were made earlier on the moveable
sheave.
4. Torque spider to specification using the holding
fixture and spider tool. Torque with smooth motion to
avoid damage to the stationary sheave.
TORQUE
Drive Clutch Spider:
290 ft-lbs (393 Nm)Apply 263 Loctite®
5. After the spider has been torqued, remove the clutch
assembly from the holding fixture and inspect the
shaft and sheave alignment marks made during
disassembly.
If the marks are no longer in alignment, the clutch will
not be in balance and the drive clutch assembly must
be replaced.
6. Install shift weights using new lock nuts on the bolts.
7. Reinstall clutch spring.
8. Reinstall cover, making sure that "X" or the marks
that were made earlier the on spider, aligns with "X"
or the marks that were made earlier on the cover.
9. Torque cover bolts evenly to specification.
TORQUE
Drive Clutch Cover Bolts:
100 in-lbs (12 Nm)
6.24
NOTE
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.