Polaris RANGER XP 900 2013 Manual page 128

6. Carefully place lower crankcase on upper case,
making sure the oil pump drive chain is fed through
the lower crankcase.
7. Tap lower crankcase with a rubber hammer to seat
the case halves together.
8. Inspect crankcase mating surfaces to be sure they
are joined properly. Investigate the cause of any
gaps.
t
9. Install the eight M10 , one M6
lower crankcase bolts. Tighten all bolts lightly by
hand.
NOTE
Install new M10 lower crankcase bolts.
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.
10. Torque lower crankcase bolts in sequence to
specification. Repeat sequence to verify final torque.
y u
and two M8
11. Rotate the engine so the cylinder is facing up.
12. Install the two M8
crankcase bolts. Tighten all bolts lightly by hand.
TORQUE
Lower Crankcase Bolts:
M10 Bolts:
Torque in sequence
Step 1: 9 ft-lb (12 Nm)
Step 2: 21 ft-lb (28 Nm)
Step 3: Tighten add'n 90°
M8 Bolts:
26 ft-lb (35 Nm)
M6 Bolts:
9 ft-lb (12 Nm)
i
and eleven M6
ENGINE
3
o
upper
3.71