Polaris RANGER XP 900 2013 Manual page 130

21. Apply a thin, continuous film of Crankcase Sealant
(PN 2871557) to sump cover mating surface
not allow sealant to dry before assembly.
NOTE
Dipstick must be removed before oil pan is assembled
to the engine. Failure to do this will damage the
dipstick.
h
22. Install the oil sump cover
j
23. Install the thirteen M6
k
retain the oil sump cover
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.
24. Torque the oil sump cover bolts in sequence to
g
. Do
onto the crankcase.
25. Reinstall the crankcase drain plug if previously
26. Rotate the engine so the cylinder is facing up.
27. Reinstall the oil cooler
and three M8 bolts that
to the crankcase.
specification. Repeat the sequence to verify final
torque.
TORQUE
Oil Sump Cover Bolts:
M6 Bolts:
9 ft-lb (12 Nm)
M8 Bolts:
26 ft-lb (35 Nm)
removed. Torque drain plug to specification.
TORQUE
Crankcase Drain Plug:
11 ft-lbs (15 Nm)
l
, if previously removed. Use
new O-rings upon installation
ENGINE
3
1(
.
3.73