Checking Adjustable Variables; Changing To Setting Mode - ProMinent Sigma X Operating Instructions Manual

Confirming adjustable variables

8.2 Checking adjustable variables

Continuous displays
Secondary displays

8.3 Changing to Setting mode

4. To run through the figures again, if necessary (possibly because of
an incorrect figure), when you get to the last figure press
[Priming] again - see above Figure, point c).
ð Now you can start from the beginning again.
[Clickwheel] 1x.
Press the
ð The software saves the entry.
Before adjusting the pump, you can check the current settings of the
adjustable variables:
[Clickwheel] if the pump is showing a continuous
Simply turn the
display.
[Clickwheel] engages when you turn it, you will
ð Each time the
see a different continuous display.
The number of continuous displays depends on the iden‐
tity code, the selected operating mode and the con‐
nected additional devices – see overview of "Continuous
displays" in the appendix.
The lowest line of a continuous display shows different information (which
cannot be adjusted in the secondary display) - see "Continuous displays
and secondary displays" overview in the appendix.
You can access secondary displays via any continuous display as follows:
[Clickwheel] for 3 seconds.
1. Press the
ð A frame appears around the secondary display.
2. Providing there is a frame, you will see a different secondary display
[Clickwheel] engages when turned.
each time the
When you reach the secondary display you wish, leave the
[Clickwheel] and wait briefly.
In a continuous display, if you press
'Menu' . For more information refer to the following
mode changes to
chapter entitled "Set up / Menu".
'Access protect.' only 'Menu' or 'All' has been set up (top right
If under
lock symbol), then after pressing the
'Password' .
Basic set-up principles
'Menu' , the pump in Setting
[Clickwheel] , first enter the
43