Assembly; Base; Space Requirement - ProMinent Sigma X Operating Instructions Manual

6

Assembly

6.1 Base

h
Fig. 12: Base

6.2 Space requirement

A
A
Fig. 13: Space requirement
Compare the dimensions on the dimensional drawing with those of the
pump. Clarify any deviations before assembling.
WARNING!
Danger of electric shock
If water or other electrically conducting liquids penetrate
into the drive housing, in any other manner than via the
pump's suction connection, an electric shock may occur.
–
P_MOZ_0016_SW
WARNING!
The pump can break through the base or slide off it
–
CAUTION!
If your Sigma S2Cb is to be installed in place of a Sigma
S2Ca, a base plate order no. 1044841 is possibly
needed to lift the liquid end.
Dosing rate too low
Vibrations can disturb the liquid end valves.
–
CAUTION!
Danger from incorrectly operated or inadequately main‐
tained pumps
Danger can arise from a poorly accessible pump due to
incorrect operation and poor maintenance.
–
–
P_MOZ_0018_SW
Position the pump so that control elements, such as the stroke length
adjustment knob, the indicating dial A or the oil inspection windows, are
accessible.
In doing so, ensure there is sufficient clearance to carry out an oil change
(vent screws, oil drain plugs, oil trough ...).
If the HMI is mounted remotely from the pump, fit a clearly marked Stop
mechanism in the direct vicinity of the pump in the event of an emergency.
Position the pump so that it cannot be flooded.
Ensure that the base is horizontal, flat and perma‐
nently load-bearing.
Do not allow the base to vibrate.
Ensure that the pump is accessible at all times.
Adhere to the maintenance intervals.
Assembly
25