Operation
11
Operation
11.1
Manual operation
Stop/start pump
Priming
Starting a batch
Acknowledge errors
Check adjustable variables
Change directly adjustable variables
Changing a variable in the relevant contin‐
uous display:
64
WARNING!
Fire hazard with flammable media
Only with flammable media: They can be ignited by
oxygen.
–
The pump may not work if there is a mixture of feed
chemical with oxygen in the liquid end. A specialist
may need to take appropriate actions (using inert
gas, ...).
This chapter describes all the operating options in a continuous display
(several symbols and the pressure display appear at the top in the black
bar) for the trained person at the pump.
Please also refer to the "Operating/Setting overview"
–
and "Continuous displays and secondary displays"
overviews at the end of the operating instructions
and also the "Overview of equipment and control
elements" chapter.
[STOP/START] .
Stop the pump: Press
Start the pump: Press
[STOP/START] again.
[Priming] .
Press
In
'Batch' operating mode: Turn the [Clickwheel] in a continuous display
'Push' continuous display appears and then press the
until the
[Clickwheel] .
[Clickwheel] to acknowledge error messages that require
Press the
acknowledgement.
In a continuous display: Another continuous display appears each time the
[Clickwheel] engages when turned. (The number depends on the configu‐
ration).
[Clickwheel] .
1.
Press the
ð The variable can be changed (highlighted).
2.
Turn the
[Clickwheel] .
ð The variable is changed.
[Clickwheel] .
3.
Press the
ð The variable is saved (the dark highlighting disappears).
If the "lock" - "lock all" has been set - see
X Control type' on page 65 , first enter the 'Password' after pressing the
[Clickwheel] .
Ä 'Set-up overview of the Sigma