Table of Contents
Advertisement
Basic set-up principles
Confirming adjustable variables
11.2
Checking adjustable variables
Continuous displays
Secondary displays
11.3
Changing to Setting mode
46
[Clickwheel] 1x.
Press the
ð The software saves the entry.
Before adjusting the pump, you can check the current settings of the
adjustable variables:
[Clickwheel] if the pump is showing a continuous
Simply turn the
display.
[Clickwheel] engages when you turn it, you will
ð Each time the
see a different continuous display.
The number of continuous displays depends on the iden‐
tity code, the selected operating mode and the con‐
nected additional devices – see overview of "Continuous
displays" in the appendix.
The lowest line of a continuous display shows different information (which
cannot be adjusted in the secondary display) - see "Continuous displays
and secondary displays" overview in the appendix.
You can access secondary displays via any continuous display as follows:
[Clickwheel] for 3 seconds.
1.
Press the
ð A frame appears around the secondary display.
2.
Providing there is a frame, you will see a different secondary display
[Clickwheel] engages when turned.
each time the
When you reach the secondary display you wish, leave the
[Clickwheel] and wait briefly.
In a continuous display, if you press
mode changes to
'Menu' . For more information refer to the following
chapter entitled "Set up / Menu".
If under
'Access protect.' only 'Menu' or 'All' has been set up (top right
lock symbol), then after pressing the
'Password' .
'Menu' , the pump in Setting
[Clickwheel] , first enter the
Advertisement
Table of Contents
