Key Functions - ProMinent Sigma X Operating Instructions Manual

Overview of equipment and control elements

4.2 Key functions

Key Application
[Back]
press
press
[STOP/
START]
[Menu] press
[Priming]
press
[Clickwheel] press
[Clickwheel] turn
18
The pump only shows the metering volume and the
capacity in the calibrated state in l or l/h or in gal or
gal/h.
In the continuous displays
-
Stop pump,
Start pump
Move to the menu
Priming *
Start batch (only in 'Batch' operating
mode),
Acknowledge errors
Switch between the continuous dis‐
plays
* When priming the pump does not run at maximum
stroke rate.
If [Priming] is pressed in 'Stop' state, then [Priming]
has top priority as long as the button is pressed.
Refer to the "Set-up basics" chapter to adjust figures
In the menu
Move back to the previous menu
point (or a continuous display) -
without saving
Stop pump,
Start pump
Move back to a continuous display
Priming *
Move to next menu option (or a
continuous display)
Confirm entry and save
Change figure or change selection