System - ProMinent Sigma X Operating Instructions Manual

9.3.4.4 'mA-Output (optional)'
'Flow control'
9.3.4.5
'Diaphragm rupture'
9.3.4.6

'System'

9.3.5
'Relay2' - see Ä Chapter 9.3.4 ' 'Inputs/outputs' '
For more information on
on page 51 .
'Menu / Information è Settings è Inputs/outputs è mA-Output
...'
è
You can set which current range is to be used at the mA output here.
'Function' , you can then set whether the current stroke rate
Under
'strokes / minute' ) is to be signalled at the mA output or the capacity
(
(litres / hour).
'Menu / Information è Settings è Inputs/outputs è Flow control
...'
è
The setting options for the 'Flow control' function are
only available if a flow control is electrically installed. The
symbol for flow control appears:
A metering monitor, such as a Flow Control (also DulcoFlow
ister the individual pressure impacts of the pump and report them back to
the pump.
It is possible to switch the function on and off under
The pump switches to fault mode if this feedback isn't provided a certain
number of times in succession as set under
'at Auxiliary' , it is possible to set whether the function is to be deac‐
Under
tivated with auxiliary frequency.
'Signalling' , you can set whether the control is to trigger an error or
Under
a warning when the tolerance is exceeded.
'Menu / Information è Settings è Inputs/outputs
Diaphragm rupture è ...'
è
The setting options for the 'Diaphragm rupture' function
only exist if a diaphragm rupture indicator is electrically
installed. The symbol for diaphragm appears
In the 'Diaphragm rupture' sub-menu you can select whether the pump
generates a warning message or an error message in the event of a dia‐
phragm rupture.
'Menu / Information è Settings è System è ...'
'Menu'
Set up/
.
), can reg‐
®
'Activation' .
'Tolerance / strokes' .
.
53