Air Humidity; Degree Of Protection And Safety Requirements; Installation Height; Electrical Connection - ProMinent Sigma X Operating Instructions Manual

SST liquid end
16.5.3

Air humidity

Air humidity
16.5.4

Degree of protection and safety requirements

Degree of protection
Safety requirements
16.6

Installation height

16.7

Electrical connection

Electrical data for the S2Cb pump
Data
Minimum temperature
Data
Max. temperature long-term at max. oper‐
ating pressure
Max. temperature for 15 min at max. 2 bar
Minimum temperature
Air humidity, max. 95% relative humidity, non-condensing.
Protection against contact and moisture:
The pump is designed in compliance with IP65 / NEMA4X Indoor (IEC
60529, EN629).
INFORMATION!: A CAN plug or the sealing cap provided needs to be
attached to the CAN socket for the HMI to guarantee protection against
contact and moisture.
Degree of protection:
1 - Mains connection with protective earth conductor
Data
Maximum installation height*:
* with standard pumps: Fit at higher installation heights at your own risk.
with ATEX pumps: We urgently advise that you contact a specialist for
ATEX motors at higher installation heights!
The electrical data does not relate to the motor, but the
pump, which is connected as a whole unit.
Use the motor data sheet in the appendix for the motor
electrical data.
Identity code specification "Electrical power supply" - "U": 100 - 230 V ±
10%, 240 V ± 6%, 50/60 Hz
Technical data
Value Unit
-10 °C
Value Unit
90 °C
120 °C
-10 °C
Value Unit
1000 m above
standard
zero
85