Timer 'Activation; Setting The Timer - ProMinent Sigma X Operating Instructions Manual

'activation'
9.4.1 Timer

'Setting the timer'

9.4.2
9.4.2.1 Administration functions for commands
'Init' Initial conditions
9.4.2.2
'Time event' and Time
9.4.2.3 Selecting the
'Menu / Information è Timer è Activation è ...'
'Activation' to 'active' .
To activate the timer, set
A program set up with an uncalibrated pump will not
function with the calibrated pump – and vice versa.
'Menu / Information è Timer è Set timer è ...'
You can create commands (program lines) for a timer program in the
timer' menu.
You can create up to 32 commands (program lines).
You can then use the administration functions to manage the commands -
Ä Chapter 9.4.2 ' 'Setting the timer' ' on page 55 .
'Clear all' function to clear all commands (the program).
Use the
Create the command as follows:
1 - Create a command (program line)
2 - Select the triggering event and time
3 - Select the action and value
4 - Check the command
5 - Save command by pressing the Clickwheel
6 - Create the next command if necessary
The following administration functions are available to manage the com‐
mands (program lines):
'Display' (only if commands entered)
n
'Change' (only if commands entered)
n
'Clear' (only if commands entered)
n
'New'
n
'New' to create a new command.
Use
Use 'Init' to specify initial conditions at the start of the program - see
Ä Chapter 9.4.2.4 'Select the action and value' on page 56 .
You can select a time event (cycle) and a time as well:
'Menu'
Set up/
'Set
55