Mode Setting; Frequency Conversion; Output Setting - Delta Modulon DPH Series User Manual

MODE SETTING

Item
On-Line Mode
Green Mode
ECO Mode
Energy Recycle
Mode
Frequency
Conversation
Mode

7.10.3 Output Setting

Path:
SETUP
After entering the OUTPUT SETTING screen*
Please contact Delta customer service for assistance.
Modulon DPH Series
UPS-1.1 MEASUREMENT SETUP
Mode Setting
Select to change system mode
On-Line Green
Set up the UPS in On-Line mode. In On-Line mode, it is the inverter
to supply power to the connected loads.
Set up the UPS in Green mode. In Green mode, it is the inverter to
supply power to the connected loads and the power modules take
turn to rest according to the situation of total load capacity.
Set up the UPS in ECO mode. In ECO mode, it is the bypass to
supply power to the connected loads. It is suggested that you set
the UPS in ECO mode only when there is stable main AC power.
Otherwise, power supply quality will be compromised.
Set up the UPS in Energy Recycle mode. In Energy Recycle mode,
the full load output can be simulated for the aging test without real
output to the loads.
Set up the UPS in Frequency Conversation mode. In Frequency
Conversation mode, it is the inverter to supply power to the
NOTE:
single UPS but not to parallel UPSs.
MAINTENANCE LOG IN EVENT LOG
Administrator
Energy
ECO
Recycle
Description
Frequency Conversion mode is only applicable to
1
(shown in the figure below), you can set
7-32
10:15
May 25,2018
Bypass
Frequency
Conversion