Table of Contents
Advertisement
Chapter 2
3. Reinsert the 24 mm bolt through the brake pedals and replace the washers.
Note:
One washer is installed between the pedals and one washer is installed between
the left pedal and the steering column. When reassembling the brake pedals and brake
stop weldment bracket, these washers must be replaced in the same locations.
Connect the Clutch Sensor Cable
1
Note:
IVT
tractors will not use the "Clutch" connection on the base cable. Complete this
2
procedure on
PST
1. Locate the clutch sensor on the steering column to the left of the brakes and dis-
connect the factory wiring harness.
2. Tee the orange clutch cable (P/N 115-2610-016) to the factory connectors:
a. CL2 to the factory sensor
b. CL1 to the factory wiring harness previously connected to the sensor
1
Infinitely Variable Transmission
2
PowerShift Transmission
84
installations only.
Advertisement
Table of Contents
