Install The Chassis Cable - Smartrax Md-Only Systems (If Applicable); Connect Smartrax Md To An Existing Chassis Cable (If Applicable) - Raven SmarTrax MD Series Installation Manual

Case ih afx/x230 combines, windrower wd/wdx & new holland cr/cx combines, windrower h/hw
Table of Contents

Advertisement

Chapter 4
Ensure the terminator (P/N 063-0172-369) supplied with the node harness is securely installed in the
6.
remaining 4-pin Deutsch connector.
Install the Chassis Cable - SmarTrax MD-
Only Systems (If Applicable)
If the machine does not contain an existing chassis power system (such as AutoBoom, product control, etc.), it
is necessary to install the chassis power cable to operate the SmarTrax system. If a CAN system already exists
on the machine, refer to Connect SmarTrax MD to an Existing Chassis Cable (If Applicable) below to connect
power to the SmarTrax MD system.
Note:
The chassis cable is sold separately. Contact your local Raven dealer for ordering information.
Locate the SmarTrax chassis cable (P/N 115-4001-085).
1.
Connect the TO SMARTRAX NODE connector from the chassis cable to the round 16-pin connector on the
2.
node harness (P/N 115-4001-157).
Connect the TO CONSOLE CABLE connector to the Raven console cable.
3.
Install a terminator (P/N 063-0172-369) on the CAN cable connector.
4.
Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.
5.
Note:
The REMOTE SWITCH connector is not used in the SmarTrax MD system. Ensure the cable is
secured away from moving parts and heat sources.
Connect the ring terminals to the battery.
6.
Note:
The positive connectors are fused.
Connect SmarTrax MD to an Existing
Chassis Cable (If Applicable)
Note:
The SmarTrax interface tee is sold separately. Contact your local Raven dealer for ordering
information.
Locate and disconnect the connection between the Raven console cable and chassis cable on the
1.
machine's existing CAN system.
Install the SmarTrax interface tee cable (P/N 115-4001-070 or 115-4001-071) between the chassis and
2.
Raven console harness.
Connect the SmarTrax MD node harness (P/N 115-4001-157) to the remaining SmarTrax interface tee
3.
connection.
26
Case IH AFX/X230 Combines, Windrower WD/WDX & New Holland CR/CX Combines, Windrower H/HW Series SmarTrax™ MD Installation Man-

Advertisement

Table of Contents
loading

Table of Contents