Table of Contents
Advertisement
2. Disable the Section Control check box option.
Note:
Leaving section control on will cause gaps in the coverage map and may cause
issues with OMNiDRIVE™ route planning.
Networking
1. From the main screen, select the Settings icon in the lower, left corner of the display
and select the Networking button.
2. Disable the Enable WiFi option.
Note:
OMNiDRIVE™ may encounter communication errors if this option is not
disabled.
Enable the On-Screen Master Switch
1. From the main screen, select the Settings icon in the lower, left corner of the display
and select the Master Switch button.
2. Enable the On-Screen option. This option allows the combine operator to use the
CR7™ touch screen to toggle coverage mapping on and off while harvesting to record
area covered or harvested.
228
Advertisement
Table of Contents
