Table of Contents
Advertisement
Chapter 2
3. Route and connect the round, 9-pin connector to the J1939 diagnostic port in the
tractor cab.
Note:
It is preferred that the OMNiDRIVE™ system is connected directly into the
tractor J1939 port. A pass-through connection is available on the J1939 breakout cable
for diagnostics or other devices and tee into the existing connection.
Proceed to the "Mount and Connect the Lockout Switch" below topic to proceed with the
installation process on the tractor.
Mount and Connect the Lockout Switch
Recommended Tools
Metric socket set - 5 to 24 mm
l
OMNiDRIVE™ System Diagram - Tractor
1. Mount the Lockout Switch (P/N 063-2610-008) to the hand rail using the integrated
bracket and four bolts provided on the back of the switch.
2. Connect the 4-pin Lockout Switch extension cable (P/N 115-2610-027) to the lockout
switch.
78
Advertisement
Table of Contents
