Combine Installation; Combine Kit Contents - Raven OMNiDRIVE Installation And Operation Manual

Chapter 2
d. "Mount the Combine Roof Array" on page 40
e. "Connect Combine OMNiDRIVE™ System Cables" on page 47
3. Review and complete the installation procedures on the tractor on which the
OMNiDRIVE™ system will be installed:
John Deere 8R Installation Overview
Note: Click the links below for more detailed steps to complete the installation on
your tractor.
a. "Tractor Kit Contents" on page 55
b. "Cab Preparation" on page 60
c. "Populating the OMNiDRIVE™ Device Plate" on page 64
d. "Mount and Connect the Lockout Switch" on page 78
e. "Mount and Connect the Radar Assembly" on page 91
f. "Install the Brake System and Clutch Harness" on page 80
g. "Connect the Steering Valve Harness" on page 88
h. "Install the Camera System" on page 97
i. "Install the Flood Lighting System" on page 105
j. "Connect the RS Lite and StarFire™ Receiver" on page 109
k. "Install the Antenna Bracket" on page 114
l. "Install the Armrest and Foot Throttle Harness" on page 119
m. "Power the OMNiDRIVE™ System" on page 137
n. "Mount and Secure the OMNiDRIVE™ Device Plate" on page 142
4. Proceed to the field provisioning procedures to configure the OMNiDRIVE™ system
and link the tractor,
will be present for field operations. Refer to the "Field Provisioning Overview" on
page 144 for additional assistance with starting the field provisioning procedures.

Combine Installation

Combine Kit Contents

The following parts are required for communication with the OMNiDRIVE™ system.
1
The combine that may assign paths to, and may sync with, the OMNiDRIVE™ tractor. One
controlling combine is required for all OMNiDRIVE™ locations.
24
controlling combine
1
, and any non-controlling combines which