Install The Autonomous Switch; Arm Rest Harness Connections - Raven OMNiDRIVE Installation And Operation Manual

Chapter 2

Install the Autonomous Switch

1. Remove the top of the arm rest by removing the bolts underneath the bottom of the
arm rest.
2. Remove a cap over an open slot in the arm rest.
3. Insert the autonomous on/off bypass switch (P/N 412-2011-116) in the open slot.
Make sure that the OMNiDRIVE™ symbol is toward the front of the tractor.

Arm Rest Harness Connections

1. Route the supplied IVT CM2 arm rest cable (P/N 115-2610-066) up through the open-
ing in the bottom panel of the arm rest.
120