Calibrations With Device Tool Program; General - Planmeca Viso Technical Manual

5.3 Calibrations with Device Tool program

5.3.1 General

Introduction
Technical manual
2. Loosen three patient support base attachment screws (1) and adjust the
base backwards/forwards (2). If the front-ball's height is smaller than
width, move the base forwards and vice versa. Tighten the attachment
screws.
With Planmeca Device Tool program, it is possible to perform the following
tasks:
• Update Planmeca Viso system software
• Calibrate Planmeca Viso X-ray unit
• Carry out 3D quality assurance (Q/A) tests
• Configure Network Settings
5 Adjustments and calibrations
Planmeca Viso 59