Planmeca Viso Technical Manual page 98

5 Adjustments and calibrations
Adjustment in depth
92 Planmeca Viso
the space between the columns on the left side is equal to the space on
the right side (4), and the moving column is parallel with the stationary
column.
4. Tighten the attachment screws.
1. Drive the column near the lowest position (1).
2. With a spirit level, check that the moving column is parallel with the
stationary column in depth (2).
3. Loosen the lower attachment screws located on the left and right sides of
the column (3).
Technical manual