Ricoh PRIPORT VT 2000 Series Service Manual page 185

28 February '91
8. Installing the Ink Cartridge
a. Open the front door and lower the
ink holder.
b. Remove the ink cartridge cap.
c. Insert the ink cartridge into the ink
holder and return the ink holder to
the original position.
d. Close the front door.
9. Idling
a. While holding down the "0" key on
the operation panel, press the Re-
set key.
b. If + D blinks on the operation
panel, repeat the above procedure.
10. Test Printing
a. Adjust the original guide to match
the original size.
b. Set the original face down.
c. Input the desire number of prints
with the number keys and press the
Master Making key.
NOTE: With a new machine, the
master paper misfeed
indicator
because there is no master
yet on the drum. Press the
Reset key, then press the
Master Making key.
d. After one sheet of paper is deliv-
ered, make prints at the lowest print
speed (1) until the print image den-
sity stabilizes. Use a test chart to
check for changes in the image den-
sity.
e. Check the copy image after about
one hundred prints.
+ F blinks
3-14