28 February '91
[G] Front and rear original table frames (3 screws each).
•
Remove the operation panel cover [D] and rear cover [C] to remove the
front and rear original table frames (See page 5-1).
[H] Original table (6 screws).
•
Remove front and rear original table frames [G] to remove the original
table.
NOTE: When installing the original table, make sure both original guides
[J] are set in the same position in the grooves (See illustration).
[I] Original table cover (3 screws).
•
Slide the scanner unit to the left.
[J]
[J]
Good
[G]
[H]
5-2
[I]
[J]
No Good