Ricoh PRIPORT VT 2000 Series Service Manual page 208

5. DESIGNATED AREA CHECK MODE: VT2500
The command sheet image (designated area) and the original image can be
printed at the same time to check the designated area and the positioning of
the image within the designated area as follows:
1) Turn off the power switch.
2) Turn on the power switch while pressing the Make-up Key and the Reset
Key.
3) Press the Make-up Key ([Fn] is displayed in the counter.)
4) Press the "8" key ("8" is displayed in the counter.)
Press the "8" key
5) Set the command sheet and the original on the original table and press
the Print Start key to make copies.
* If white paper is used as an original, only the command sheet (the line
showing the designate area) is printed.
Turn on the power switch
while pressing these keys.
4-19
28 February '91