Table of Contents
Advertisement
28 February '91
9.10 ELECTRICAL TIMING:
Master
Cut
1st Drum
Position SN
Main Motor
Forwarding
Right Cutter SW
Vacuum Fan
Air Knife Motor
T1:
After the master is cut and the right cutter switch turns on, the main
motor starts rotating. At the same time, the air knife motor and the
vacuum fan also turn on and stay on until the first drum position sen-
sor turns on 4 times.
T2:
When the Print Start key is pressed, the main motor starts rotating
and the air knife motor and the vacuum fan also turn on. Then, when
the counter indicates "0", the main motors turn off after the first drum
position sensor turns on 4 times.
Master Wrap
2-130
Print Start
Key
Counter
ON
"0"
- Quick Links:
- Overall Machine Information
Hide quick links:
Advertisement
Table of Contents
