Ricoh PRIPORT VT 2000 Series Service Manual page 209

28 February '91
Original
1) The designated areas marked using a pencil are depicted by dashed
lines. This is because the line marked using a pencil is low density and
thin, therefore the designated area is not recognized as a closed loop
even if the line on the command sheet is a closed loop.
Therefore, the designated area can not be memorized.
2) The designated area marked using a black felt-tip pen is printed within
the closed loop.
As the line of the designated area on the printed paper is a closed loop,
the designated area is memorized.
Printed image using "Fn 8"
4-20
Command Sheet
Felt-tip Pen
Pencil