Ricoh PRIPORT VT 2000 Series Service Manual page 254

[D]
<Step 2>
This procedure should only be used when the proper pressure cannot be
achieved in step 1.
1. Stack about 100 sheets of 65 g/m
paper table until it stops automatically.
2. Set the paper feed roller pressure adjusting lever to the upper position.
3. Remove the front cover, the main board, the image processing board.
4. Remove the master feed unit.
5. Align the lower adjusting plate notch with the center notch of the link [D]
and tighten the screw [E].
6. Hook a tension gauge (500-gram range) to the paper feed roller shaft [F]
and insert a test sheet between the paper feed roller and the sheets of
paper. Then hook a tension gauge (100-gram range) to the test sheet and
apply a 100-gram load. In the above condition, gradually pull up the
tension gauge hooked to the shaft and make sure that the test sheet can
be pulled out when the tension gauge shows 250 ± 5 grams.
7. If not, adjust the pressure by moving the mounting position of the shaft
[G].
[G]
[E]
250±5 g
100 g
[F]
2 paper on the paper table. Lift up the
5-41
28 February '91