2.3 TRANSPORT ROLLER PRESSURE ADJUSTMENT:
VT2300/VT2500
[C]
Purpose : To ensure that the original does not skew
1. Set the ADF ON/OFF switch to OFF.
2. Open the scanner unit [A] and place strips of paper (45 g/m
front and rear ends of the transport roller [B].
3. Close the scanner unit.
4. Confirm that the strips of paper can be pulled out at both ends of the
roller with the same amount of force.
5. If the pressure is not the same at both ends, loosen the mounting screw
[C] and adjust the transport roller pressure by sliding the adjustment plate
[D] up or down.
6. Tighten the mounting screw after adjusting the roller pressure.
[D]
[A]
5-5
28 February '91
[B]
2
) over the