Ricoh PRIPORT VT 2000 Series Service Manual page 250

6.6 MASTER EJECT BELT/ROLLER REPLACEMENT
[F]
1. Remove the master eject unit. (See page 5-36.)
2. Remove the 2 springs [A] on both sides.
3. Remove the upper shaft [B] (2 E-rings).
4. Remove the lower shaft [C] (2 E-rings).
5. Remove the gear [D] (1 E-ring).
6. Remove the gear [E] (1 Allen Screw).
7. Remove the gear [F] (1 E-ring).
8. Remove the E-rings [G] to pull out both upper (30 φ ) and lower rollers
(20 φ ) as a set.
9. Remove the Angle [H].
10. Remove the Plate [I].
11. Remove the Belts [J].
12. Remove the Rubber Rollers (30 φ , 20 φ ) [K].
[C]
[B]
[J]
[K]
5-37
28 February '91
[A] [G]
[H]
[I]
[D]
[E]
[G]