Ricoh PRIPORT VT 2000 Series Service Manual page 293

28 February '91
10.3 EXIT PAWL CLEARANCE ADJUSTMENT
Purpose: To ensure that the printing paper is delivered without paper wrap or
damage to the screen.
1. Remove the rear cover of the machine.
2. Manually turn on the paper feed and the printing pressure solenoids.
Using a spanner (10 mm), gradually rotate the drum rotation shaft
counterclockwise to move the exit pawl [A] to the drum.
3. Make sure that the clearance between the drum and the exit pawl is 0.3
to 0.5 mm when the exit pawl is at the position closest to the drum.
4. If incorrect, open the master eject box and loosen the hexagon nut [B] of
the exit pawl drive arm. Then adjust the clearance by turning the screw
[C].
5. Check adjustment by repeating steps 2 and 3.
[C]
[B]
0.3 -- 0.5 mm
5-80
[A]