Ricoh PRIPORT VT 2000 Series Service Manual page 252

7.2 PAPER TABLE HEIGHT ADJUSTMENT
[C]
Purpose: To ensure smooth paper feed.
1. Set the paper feed pressure adjusting lever to the upper position.
2. Remove the front cover of the machine.
3. Access I/O check mode (See page 4-11).
Enter "0" in the memory display and "4" in the copy counter.
•
4. Press the Print Start key to raise the paper table.
5. After the paper table stops, insert a scale into the slot at the end of the
paper table. Make sure that the distance between the lower stay [A] and
the upper face of the table is 147.5 to 148.5 mm.
6. If not, loosen the screw [B] and adjust the position of the actuator [C].
7. After adjustment, repeat step 5 again by lowering and raising the paper
table several times.
NOTE: When mounting the actuator, make sure that the actuator does not
contact the paper table height sensor [D].
[D]
148±0.5 mm
[B]
[A]
5-39
28 February '91